1、根據(jù)要求的水平高度拉好水平線，縱橫垂直均需拉好；

2、按合適的間距吊裝卡齒龍骨，一般間距1-1.2米，吊桿距離按輕鋼龍骨的規(guī)定分布；

3、把預裝在龍骨上吊件，連同方通龍骨裝在輕鋼龍骨下面，方通龍骨間距一般為1米，全部裝完后必須調(diào)整至水平；

4、將鋁方通、木紋鋁方通系列按順序扣掛在龍骨上，再將倒鎖片壓下，方通端頭應(yīng)保持10mm或20mm的距離；

5、安裝木紋鋁方通時必須帶手套，如不慎留下指印或污漬，可用洗潔精開水洗后抹干即可。

1, according to the required horizontal height pull the horizontal line, vertical and horizontal vertical need to pull well;

2, according to the appropriate spacing hanging teeth keel, general spacing 1-1 .2 meters, hanging rod distance according to the light steel keel distribution;

3, pre-mounted on the keel hanging parts, even with the square dragon bone mounted on the light steel keel, the square keel spacing is generally 1 meter, after all the installation must be adjusted to the level;

4, aluminum square pass, wood aluminum square pass series in order to hang on the keel, and then press the relock plate, the square end should maintain a distance of 10mm or 20mm;

5, the installation of wood aluminum square must wear gloves, if inadvertently left fingerprints or stains, can be washed with detergent boiling water after drying.